CARE & MAINTENANCE
Regularly clean your appliance between uses, especially after extended
periods of storage. In order to extend the life and condition of unit,
follow best practices detailed in this manual.
! WARNING
When not in use, turn unit
controls and gas source OFF.
! WARNING
This appliance will be hot
during and after use. Use
insulated oven mitts or
gloves for protection from
hot surfaces or splatter from
cooking liquids.
! CAUTION
NEVER
handle hot parts
with unprotected hands.
VALVE CHECK
Ensure gas is off at the supply shut
off valve before checking appli-
ance valves. Knobs must be locked
in OFF position.
01. To check valves, push in knobs
and release. Knobs should
spring back.
02. If knobs do not spring back,
replace valve assembly before
using appliance.
03. Rotate knobs to LOW position
then turn back to OFF position.
Knobs should turn smoothly.
GENERAL CLEANING
Ensure that the appliance and its
components are sufficiently cool
before cleaning.
• Be sure to keep the ventilation
opening(s) of the cylinder enclo-
sure free and clear from debris.
• Baked-on grease deposits may
require the use of an abrasive
plastic cleaning pad. Use only
in direction of brushed nish to
avoid damage.
• DO NOT use abrasive pad on areas
with graphics.
• If a bristle brush is used to clean
any of the cooking surfaces,
ensure no loose bristles remain on
cooking surfaces prior to cooking.
Section 01
GENERAL CARE
Care & Maintenance
! WARNING
A clogged burner
tube can lead to a fire
beneath the appliance.
! WARNING
This appliance is not
intended for and should
never be used as a heater.
! WARNING
NEVER operate this
appliance unattended. Keep
children and pets away
from appliance at
all times.
! WARNING
The use of alcohol,
prescription or
non-prescription drugs may
impair the consumer’s ability
to properly assemble or
safely operate the appliance.
! CAUTION
For residential use
only. DO NOT use for
commercial cooking.
! CAUTION
DO NOT use Citrisol,
abrasive cleaners,
de-greasers or a
concentrated cleaner on
plastic parts.
Damage to and
failure of parts may result.
BURNER MAINTENANCE
In most circumstances, burning
residue off after cooking will keep
burner clean.
• Be sure that the ow of combus-
tion and ventilation air is
not obstructed.
• Burner should be removed and
cleaned annually or whenever
heavy build-up or insects/insect
nests are found in order to ensure
that there is no blockage in the
burner portholes or venturi tubes.
• Use pipe cleaner to clear obstruc-
tions. A wire brush may be used
to remove corrosion from the
burner surfaces. (Please refer-
ence the Cleaning the Burner
Assembly section)
• When retting burner, check that
the venturi tubes of the burner t
over valve outlets.
AFTER EACH USE
PLASTIC PARTS: Wash with warm
soapy water and wipe dry.
PAINTED SURFACES: Wash
with mild detergent or nonabra-
sive cleaner and warm soapy
water. Wipe dry with so nonabra-
sive cloth.
STAINLESS STEEL SURFACES:
To maintain appliance frame’s high
quality appearance, wash with mild
detergent and warm soapy water.
Wipe dry with a so cloth aer
each use.
STORAGE
• In order to extend and maintain
the life and condition of your
appliance, we strongly
recommend that the unit be
covered when le outside for any
length of time, especially during
the winter months.
• When LP cylinder is connected
to appliance, store appliance
outdoors in a well-ventilated
space and out of reach of children.
LP cylinder should only be stored
outside, out of reach of children,
and in a cool, dry place.
• Store appliance indoors ONLY if
LP cylinder is turned o, discon-
nected, removed from appliance
and stored outdoors.
• When removing appliance from
storage, clean burner assembly
before starting appliance. (Please
reference the Cleaning the Burner
Assembly section.)
Care & MaintenanceModel 1863 | Owner’s Manual | | Owner’s Manual | Model 1863
12 13
To Next Page
Loading...
