ENGLISH
Owner’s Manual |
ENGLISH
❸
❶
❷
❹
STEP
In order for the ignitor
button to work properly, ensure that
the battery is installed correctly.
STEP
❶
Ensure that the control knob is
turned to OFF.
! WARNING
Do not lean over the appli-
ance while lighting.
! WARNING
If ignition does NOT occur
in 5 seconds, turn burner
controls OFF, wait 5
minutes and repeat lighting
procedure.
If burner does not ignite with
open valve, gas will continue
to flow out of burner and
could accidentally/inad-
vertently ignite with risk of
injury.
IGNITION |
BATTERY POWERED
PROPANE BURNER OPERATION
For proper ignition and operation of the appliance follow the steps below.
STEP
Ensure that the LPG
tank is properly connected to
the unit. Turn gas ON at the LPG
cylinder by slowly turning the OPD
handwheel halfway.
STEP
❷
Push and hold the ignitor button.
❸
Push and turn the control knob counter-clockwise to HIGH.
(Release the ignitor button when the burner lights.)
❹
Adjust the temperature to desired level.
Ignition | Battery Powered
TROUBLESHOOTING
Visit BLACKSTONEPRODUCTS.COM/SUPPORT for additional
troubleshooting.
If you CAN ignite your griddle with a match
POSSIBLE CAUSES SOLUTION
01. Dead battery or no battery. Replace with new battery.
02. Battery installed incorrectly. Ensure that the battery is installed nega-
tive end rst.
03. Ignitor wire misaligned. Ensure that the ignition needle is posi-
tioned 1/8" to 1/4" away from the burner
tube, positioned above a burner hole.
04. Damage to the ignition system. Contact customer service for replace-
ment parts.
If you CAN NOT ignite your griddle with a match
POSSIBLE CAUSES SOLUTION
05. Burner tubes are not receiving fuel. Please reference the Gas Flow section of
the Troubleshooting Chapter.
SYMPTOMS
01. Burner will not Light with ignition system
02. Pressing the ignitor button does not result in a clicking sound
If ignition does not occur in 5 seconds, turn the burner controls o, wait 5
minutes and repeat the lighting procedure.
If this does not work, to determine the cause, please try to ignite your griddle
with a match. (Please reference the Match Lighting Instructions in the
Cleaning the Burner Assembly section of the Care & Maintenance chapter.)
Insert one (1) AA battery (not
included) into the battery socket
with the positive terminal facing
out, then screw on the ignitor
button until tight. Be careful to not
over tighten.
Ensure that the ignition needle is
positioned 3-7mm away from the
burner tube, positioned above a
burner hole.
Section 01
BATTERY POWERED IGNITION
Troubleshooting
Model 1899
16
To Next Page
