ENGLISH
Owner’s Manual |
ENGLISH
Section 02
CLEANING THE BURNER ASSEMBLY
Unit burners vary, however these instructions apply to all units. Clean
burner assembly and check burner for damage. If any large cracks or
holes are found, replace burner.
STEP
Ensure that the gas is turned OFF at control knobs and gas supply.
Remove the cooking top.
STEP
Carefully detach and
remove the burner.
STEP
Run a narrow bottle
brush through each burner tube
several times. (DO NOT use
wire brushes)
Additional Methods Include:
Run a sti wire bent into a small
hook through each burner tube
several times.
Use an air hose to force air into
burner tube and out burner ports.
Check that air blows through each
hole. (Wear eye protection)
STEP
Clean any blocked ports
with sti wire such as an open
paper clip. Then, carefully replace
burners and reattach.
VERY IMPORTANT: Burner
tubes must be reengaged with the
valve openings.
STEP
Brush entire outer
surface of burner to remove grime.
! WARNING
Ensure that the fuel nozzle
is housed within the burner
opening.
VIDEO TUTORIAL
How to Clean Your Burner Tube
| Blackstone Griddle
youtube.com/
watch?v=xKQTCrFCzf8
Care & Maintenance Model 1899
22
To Next Page
