Blackmagicdesign URSA Broadcast G2 - Page 91

Clean Feed
Tap the ‘clean feed’ switch in the ‘LCD,’ ‘front SDI’ and ‘main SDI’ menus to disable allstatus text
and overlays for that output, except the record tally indicator.
Your URSA Broadcast G2 LCD touchscreen will still display a record tally in
clean feed mode
NOTE LUTs will still be applied to outputs with ‘clean feed’ enabled. Todisable LUTs,
disable the ‘display LUT’ switch in the ‘Monitor’ menu for thatoutput.
Display 3D LUT
Your URSA Broadcast G2 can apply 3D LUTs to any output to approximate the look of color
graded footage. This is especially useful when shooting with ‘film’ dynamic range as it can
produce an intentionally ‘flat’ low contrast image.
If your URSA Broadcast G2 has a 3D LUT active, use this setting to independently apply that
LUTto your LCD touchscreen, front or main SDI output.
NOTE For more information on loading and using 3D LUTs, see the ‘LUTS’ section of
this manual.
Zebra
Tap the ‘zebra’ switch in the ‘LCD,’ ‘front SDI’ and ‘main SDI’ menus to enable zebra guides
for those outputs. For more information on zebra guides and setting zebra levels, see the
‘touchscreen features’ section in this manual.
Focus Assist
Tap the ‘focus assist’ switch in the ‘LCD,’ ‘front SDI’ and ‘main SDI’ menus to enable focus assist
for those outputs. For more information on focus assist and setting focus assist levels, see the
‘touchscreen features’ section in this manual.
Frame Guide
Tap the ‘frame guide’ switch in the ‘LCD,’ ‘front SDI’ and ‘main SDI’ menus to enable frame
guides for those outputs. For more information on frame guides and choosing different guides,
see the ‘touchscreen features’ section in this manual.
91Settings