Blackmagicdesign URSA Broadcast G2 - File Naming Convention; Monitor Settings

File Naming Convention
Clips are recorded in the Blackmagic RAW format, Apple ProRes and MP4 formats, depending
upon which recording format you have chosen.
The table below shows an example of the file naming convention:
A001_08151512_C001.mov QuickTime Movie Filename
A001_08151512_C001.mov Camera index
A001_08151512_C001.mov Reel Number
A001_08151512_C001.mov Month
A001_08151512_C001.mov Day
A001_08151512_C001.mov Hour
A001_08151512_C001.mov Minute
A001_08151512_C001.mov Clip Number
Still image files captured in DNG format using the still button will follow the file naming
convention for video clips, however the filename will have an ‘S001’ representing the ‘still
number’ as the last four digits of the filename in place of the clip number. For more information,
refer to the ‘Status LCDControls’ section in this manual.
Monitor Settings
The ‘monitor’ tab lets you adjust status text, overlays, and other monitoring options for your
URSA Broadcast G2’s LCD touchscreen, front and main SDI outputs. Options are arranged by
output between ‘LCD’, ‘front SDI’ and ‘main SDI’. Each of these menus have five pages of
options, which you can cycle through by tapping the arrows at the edge of your camera’s touch
screen, or swiping left or right.
Monitor Settings 1
The first page of the ‘LCD,’ ‘front SDI,’ and ‘main SDI,’ monitor tab contains identical settings for
each output. Forexample, you can set ‘zebra’ on for the LCD touchscreen, but off for the front
or main SDI outputs.
90Settings