Need help?Do you have a question about the Blackmagicdesign Videohub 12G and is the answer not in the manual?
General| Model | Videohub 12G |
|---|---|
| Manufacturer | Blackmagic Design |
| Category | Recording Equipment |
| Video Sampling | 4:2:2 |
| Audio Sampling | 48 kHz |
| SDI Video Inputs | 12 |
| SDI Video Outputs | 12 |
| Multi Rate Support | Yes |
| Ethernet | 1 x 10/100/1000 BaseT |
| Routing Matrix Size | 12 x 12 |
| Video Standards | SD, HD |
| SDI Compliance | SMPTE 424M, 292M, 259M |
| SDI Rates | Up to 12G-SDI |
| Reference Input | Tri-Sync or Black Burst |
| Power Supply | 100-240V AC |
| Maximum Data Rate | 12G |
| Control Interface | Ethernet |
| Rack Units | 1U |
| Router Control | Ethernet |
| Control | Ethernet |
| Dimensions | 483 x 44 x 200 mm (19 x 1.7 x 7.9 inches) |
Introduces various Blackmagic Videohub models and their capabilities.
Details the Universal Videohub 288 and 72, their modular design, and features.
Essential steps for connecting power and video sources/destinations to the Videohub.
Outlines methods for controlling the Videohub, including panel, USB, and software.
Step-by-step guide to switching routes using the built-in front panel controls.
Explains how to use labeled shortcut buttons for efficient route selection.
Procedure to prevent accidental changes to video routes by locking destinations.
Steps and diagrams for connecting the Videohub to an Ethernet network.
How to configure IP addresses and network settings via the front panel or software.
Details the function and features of the UVH 288 Crosspoint Card.
Overview of the Master Control Pro hardware panel features and operation.
Overview of the Smart Control Pro hardware panel features and operation.
Various methods for selecting sources and destinations using control panels.
Details on operating the Blackmagic MultiView 16's control panel.
Guide to using the Setup utility for configuration and updates.
Steps to label inputs and outputs within the Setup software for filtering.
How to select and connect to a Videohub within the Control software.
Guide to customizing pushbuttons within the Control software interface.
Configuring network settings for hardware control panels via USB.
How to label buttons on Master Control Pro using the setup utility.
Technical details of the Ethernet protocol for Videohub communication.
Information on obtaining support through online resources and direct contact.
To Next Page
