6
DO NOT ABUSE
THE POWER CORD
Never yank or pull on the power cord to disconnect
it from the mains supply socket. Never carry or
pull your air compressor by its power cord. Keep
the power cord away from heat, oil, solvents and
sharp edges. If the power cord becomes damaged
have it replaced by an authorised service facility.
EXTENSION CORDS AND REELS
This air compressor MUST be plugged directly into
a 240V AC wall socket.
This air compressor is NOT designed to be run
off an extension cord/lead. If you need extra
distance do NOT use an extension cord, USE A
LONGER AIR HOSE.
The use of extension cords may cause power
voltage loss and will result in damage to the
motor. This will NOT be covered under warranty.
SECURE THE WORK PIECE
Whenever possible secure the work piece using
clamps or a vice. It is safer than using your hands or
feet and leaves both hands free to control the tool.
HOT COMPONENTS
Beware many of the components will get hot
during use. Never touch any of the metal pipes,
pump or motor as these may burn.
MAINTAIN YOUR AIR
COMPRESSOR WITH CARE
Follow the instructions for lubricating and changing
accessories. Check the air compressor power cord
periodically and if damaged have it replaced by an
authorised service facility. Keep handles clean,
dry and free from oil and grease. Ensure that
ventilation slots are kept clean and free from dust
at all times. Blocked ventilation slots can cause
overheating and damage to the motor.
DISCONNECT AIR COMPRESSOR
Ensure that the air compressor is disconnected
from the mains supply when not in use, before
servicing, lubricating, making adjustments or
when changing any accessories.
REMOVE ADJUSTING KEYS
AND WRENCHES
Form the habit of always checking to see that any
adjusting keys or wrenches have been removed
from the air compressor before operating.
AVOID UNINTENTIONAL STARTING
Ensure that the switch is in the ‘OFF’ position before
plugging the air compressor into the mains supply.
PROTECT FURNISHINGS
If using the air compressor inside your house, protect
furnishings and floors with a suitable dust sheet.
FIRE PRECAUTIONS
When using the air compressor inside your house
or workshop general fire precautions should be
observed. As a precaution it is recommended that
an expert is consulted on obtaining and using a
suitable fire extinguisher.
CLEANING YOUR AIR
COMPRESSOR
Always disconnect your air compressor from
the mains power supply before you commence
cleaning. Always ensure that your air compressor
has cooled, about one (1) hour, before cleaning
and storing. When cleaning your air compressor
use only a damp soft cloth. NEVER use liquid
or solvents of any type.standards and safety
requirements. Repairs should only be carried out
by qualified persons using original spare parts.
Failure to do so may result in considerable danger
to the operator.
To Next Page
Loading...
