To Next PageTo Next PageWhat to do if my Blagdon Pump Water Pump discharges fluid from air exhaust?
If your Blagdon Pump Water Pump is discharging fluid from the air exhaust, it could be due to diaphragm failure or a loose frontplate. Replace the diaphragm. Also, re-torque the frontplate to the manual's specifications.
Why my Blagdon Pump Water Pump pump will not start?
If your Blagdon Pump Water Pump won't start, possible causes include: * Air valve assembly malfunction/seizure * Obstructed fluid line * Obstructed diaphragm chamber * Diaphragm failure causing fluid & excessive air to be expelled through the exhaust * Diaphragm seal failure * Air valve system malfunction * Air connected to exhaust. To resolve this: * Check the carrier for freedom of movement – clean, oil, and replace if necessary. * Clean the fluid line or increase its size. * Remove any obstruction in the diaphragm chamber. * Replace the diaphragm or shaft seals. * Check all seals in the valve chest assembly. * Reconnect the air inlet.
What to do if Blagdon Pump Water Pump strokes but will not discharge?
If your Blagdon Pump Water Pump strokes but doesn't discharge, it could be due to excessive suction lift, suction line leakage, a valve ball not seating correctly or being damaged, a clogged suction line or strainer, or diaphragm failure. * Shorten the suction line. * Check and correct any suction line leakage. * Inspect the valve ball, remove any obstruction, or replace it if damaged. * Clear any clogs in the suction line or strainer. * Replace the diaphragm.
General| Model | B06 |
|---|---|
| Cable Length | 10m |
| Voltage | 230V |
| Frequency | 50Hz |
| Max Head | 5.5 m |
| Max Flow Rate | 6000 l/h |
