14
Operating Instructions
Using Gas Burners
The flame cut-off safety device (FFD); operates instantly when the safety mechanism activates due
to overflown liquid over the upper hobs.
1. The valves controlling the gas cookers have a special security mechanism. To light the
cooker, hold down the switch and turn it counterclockwise. All of the lighters will operate and
the cooker you are controlling will light. Keep the switch pressed until the cooker ignites.
2. Do not continuously operate the igniter for more than 15 seconds. If the burner does not
ignite, wait a minimum of one minute before trying again.
3. In models with the gas security system, when the flame of the cooker is extinguished, a
control valve cuts off the gas automatically. To operate the burners with the gas security
system you must press the knob and turn counter-clock-wise. After the ignition you must wait
approximately 5-10 seconds for the gas security system to activate. If the burner is
extinguished for any reason, close the gas control valve and wait a minimum of one minute
before trying again.
4. Closed Fully open Half open
5. Before operating your hob please make sure that the burner caps are well positioned. The
right placement of the burner caps are shown below.
To Next Page
Loading...
