6
Installation of your oven
TALLATION OF YOUR OV
To install the oven into the kitchen a cut out should be made in accordance with the dimensions
shown in below. Please allow for 3/ 4mm of a difference in the dimensions provided below. Please
measure the original product to ensure that the cut out details are correct.
The apparatus is to be fastened to the top by means of the two screws provided in the kit through the
holes made on the oven uprights.
The cabinet in which the apparatus is installed shall be open on the back side to ensure a sufficient
air circulation and prevent overheating.
Leave a gap of at least 20 cm
2
for air circulation if the oven is installed in a column; this is not
necessary if the oven is installed under the work top.
WARNING
As the apparatus is to be fitted in your kitchen furniture, make sure that all surfaces in contact
with the oven can resist a temperature of approx. 90°C.
To Next Page
Loading...
Need help?
General
