25
EN
13/
IF OPERATING ABNORMALITIES OCCUR
Problem Possible Causes What to do?
Food traces and deposits in the
glasses
- Items poorly arranged (mas-
ked by another larger item or
situated underneath it, items
nested or jammed together).
- Upper spray arm blocked by
cutlery or a dish etc.
- Filter poorly locked and lifting
during washing.
- Micro filter screen clogged.
- One or more holes in the spray
arm blocked.
- Arrange the items properly.
Use the most appropriate
areas and accessories for each
type of item (see instructions).
- Check that the spray arm
rotates freely. Set the basket in
the high position if necessary.
- Check the filter’s facing and that
the filter is locked in place (push
it in fully, turning it to the right)
.
- Remove all the filters and clean
them (in warm water), including
the micro filter’s screen (once
a month).
- Remove the spray arm by turn-
ing the lever a quarter of a turn
and clean it under the tap (do
not use any tool that could
damage the holes). Re-install
the spray arm.
Traces of grease - Detergent dose too low; ineffi-
cient detergent; stale product.
- Inappropriate programme
(temperature too low; duration
too short).
-
Increase the dose; try another
detergent.
- Select a programme with a
higher temperature.
• POOR WASHING RESULTS
Problem Possible Causes What to do?
The appliance will not restart - Door opened during a
washing cycle.
- Wait for the time delay to end
(controlled internally by the
appliance).
The appliance does not drain
(Cf. table fault d02).
- The cover has not been remo-
ved from the sink’s U-bend.
- Drain hose kinked.
- Filters totally blocked.
- Pump blocked.
- Remove the cover.
- Check the drain hose line
behind the machine is OK.
- Remove and clean the filters
and the drain.
- Initiate a Soaking programme
If the fault persists, call a tech-
nician.
To Next Page
Loading...
Need help?
General
