Blastrac 1-8DPS30 - Technical Specifications

24
9. Technical data
1-8DPS
Power consumption blast motor
3KW
5.5kW
Power consumption drive motor
0.18kW
Electrical connection
(voltage is given on the control
box)
230V SF 50/60Hz
400V / 50Hz
400V / 60Hz
Power supply must have a circuit breaker with D-
characteristic. (only for 5.5 and 7.5 kW blastmotor)
Blast width
200 mm
Abrasive consumption
100 g/m²
Drive speed
0 – 23 m/min
Length
1700 mm
Width
380 mm
Height
1050 mm
Weight
145 kg /155 kg
Sound emission pressure level
Uncertainty
LpA = 76 dB(A)
K= 2,5 dB
Vibration level
Less than 2,5 m/s²
Dust hose connection
Ø75 mm
Suitable filterunit
Contact Blastrac BV we will assist you with a good advice
The electrical diagrams of the electrical system are placed inside of the control panel.
Design and specifications are subject to change without notice by Blastrac BV
IMPORTANT NOTES:
The indicated values are measured on new machines. Noise and vibration levels will vary in different
circumstances. Area influences like open outside or closed inside space, ambient temperature, different
surfaces to be treated, daily use, different tools or accessories, poor maintenance, etc. will give different
values at all time and could increase the exposure level over the total working period.
The declared vibration and noise emission levels represent the main applications of the machine. The values
may be measurements from a representative sample of technically comparable machinery. The values may be
used for a preliminary assessment of exposure.