3
Table of contents
Inspection comments 2
1. Introduction 4
2. Machine description 4
3. Safety 5
3.1 Work area safety 5
3.2 Electrical safety 5
3.3 Personal safety 6
3.4 Machine safety 6
3.5 Shot / steel blasting safety 7
3.6 Maintenance safety 7
3.7 Dust collector safety 7
3.8 Transport safety 7
3.9 Signs on the machine 9
4. Initial operation 10
4.1 Control panel 10
4.2 Drive Control 10
4.3 Checkpoints of electrical safety 10
4.4 Checkpoints of machine safety 11
4.5 Manual moving of the machine 11
4.6 Connecting the drive motor to the traction wheel 12
4.7 Driving with connected drive motor 12
4.8 The abrasive valve 13
4.9 Separator 13
4.10 Abrasive sealing 13
5. Operating 14
5.1 Before switch on 14
5.2 Checking and correcting the turning direction of the motor 14
5.3 Switching the machine on 14
5.4 Operation 15
5.5 Switching the machine off 15
5.6 The blast pattern 16
5.7 Adjusting the blast pattern 16
6. Maintenance 17
6.1 Changing the liners 18
6.2 Changing the tune-up kit 18
6.3 The V-belt 19
6.4 V-belt mounting 19
6.5 V-belt tension 19
6.6 The chain drive 20
7. Selection of abrasive 21
8. Troubleshooting 22
9. Technical data 24
Contact
To Next Page
Loading...
