EBE 350 E Operating Instructions
General
Selection of abrasive
Abrasive shot S390 – S460:
Standard abrasive, suitable for about 50-60 % of all applications.
Creates a medium profile on concrete.
Applications:
removes laitance from new concrete
roughening of smooth concrete or natural stone
removes coatings with a thickness of 1-3 mm and cleaning of steel
surfaces
Abrasive shot S390 - S460 with SG18-16:
For removal of coatings from steel surfaces mix approx. 75% S390 -
S460 shot with 25% SG18 or SG16 grit. The type of grit is depending
on the profile requirements.
Applications:
removes polyurethane coatings
removes adhesive remnants
removes rubber deposits
penetrates coatings hard to remove
also suitable to be used on steel
removes non-skid coatings from navy vessels
Warning: never use abrasive harder than 45 Rockwell !
Otherwise the wear in the machine would increase
disproportionately.
19
To Next Page
Loading...