www.blaupunkt.com
BAC-PO-1414-Q11L
19
(2) Use the TIMER to configure the Auto-Off time during operation, or configure the
Auto-On time in standby mode.
(3) While configuring the TIMER, both the < > key and the < > dial are available
to adjust the desired time.
(4) With each press of the TIMER key, the value on the < > display increases from
→→
"00" "01" to "24" and back to "00" again.
(5) Configure the Auto-Off timer:
a. Press the < > key to preset the Auto-Off timer. The < > display will
flash the configured time on the screen. After configuration, the display will
return to show the operating mode after 5 seconds.
b. Press the < > key before the preset time to cancel the Auto-Off timer. The
appliance will turn off.
(6) Set the Auto-On timer:
a. While configuring the Auto-On timer, you can preset functions at the same
time.
b. Press the < > key to configure the Auto-On timer. After configuration, the
display will show the remaining time.
c. Press the < > key before the preset time to cancel the Auto-On timer. The
appliance will turn on.
d. After configuring the Auto-On timer, the appliance will remain available to
control or switch to other functions.
IV. SLEEP Mode:
(1) The appliance defaults not to SLEEP mode disabled when powered on.
To Next Page
Loading...
Need help?
General
