8
2. Pairing
a) After the earbud is taken out of the charging case, it will be power
on. Then it will connect back to the phone it was paired with
before. When the earbuds and the cellphone fails to connect back,
the earbuds will automatically enter the matching state.
b) If the earbuds are power off, you should press touch-button for
about 8s and release it when the red LED and white LED ash
quickly and alternately. You will hear “Pairing”. The earbuds are now
in “Pairing” mode.
3. Connecting
To connect your earbuds to a Bluetooth device, rst ensure the
device has Bluetooth enable and it is in pairing mode (See your
device manual for setting pairing mode). Once your earbuds are in
pairing mode, you should be able to see it in the list of Bluetooth
devices.
BTW-Pro
To Next Page
Loading...
