EasyManuals Logo

Blaupunkt ICE CUBE User Manual

Blaupunkt ICE CUBE
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
6
STEP 2
Always wait until the air cooler has stopped completely and unplug it from the mains power supply
before performing any cleaning or user maintenance.
Wipe the air cooler with a soft, damp, lint-free cloth and allow to dry thoroughly.
Do not immerse the air cooler in water or any other liquid.
STEP 1: The water tanks must be drained of any water after each use. To do so, carefully open the
access doors and pull the water tanks out from the air cooler. Unscrew the caps and tip away any
excess water. Once the water tanks have been drained, shake to remove any excess and leave to dry
with the caps off.
STEP 2: To clean the lter, lift the lter block up and slide it out of one of the sides of the air cooler
main unit. Remove any loose bres by hand and rinse with cool, clean water. Leave the lter block to
air dry if not using the air cooler immediately after carrying out maintenance. Alternatively, place the
lter into a dishwasher at 35 °C for approx. 35 minutes and then leave to air-dry.
STEP 3: Before replacing the water tanks and lter block, wipe the inside of the air cooler with an
absorbent cloth to remove any excess water from the water reservoir (located in the base of the unit).
Any limescale deposits in the air cooler can be removed with a soft, damp cloth and mild detergent.
STEP 4: Wipe the exterior of the air cooler with a soft, damp cloth and dry thoroughly. The lter block
and water tanks can be replaced once dried thoroughly.
Do not use ammable liquid, abrasive cleaning solvents, polishes or scouring pads to clean the air
cooler as this may cause damage.
Note: Clean the air cooler and all of its parts regularly to reduce the risk of limescale and bacteria
forming.
If there is any mould on the lter block or a musty smell coming from the air cooler, remove the lter
block and fully immerse in a solution of equal parts water and white vinegar. Allow the lter block to
soak for 45–60 minutes before rinsing thoroughly in warm water. Allow to air-dry.
It is advised that the lter is replaced every 6–12 months. Contact our customer service team to order a
new lter at customersupport@beldray.com
CARE AND MAINTENANCE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Blaupunkt ICE CUBE and is the answer not in the manual?

Blaupunkt ICE CUBE Specifications

General IconGeneral
BrandBlaupunkt
ModelICE CUBE
CategoryAir Conditioner
LanguageEnglish

Related product manuals