67
DEUTSCH
FRANÇAISITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
DANSK
ENGLISH
Setting TV standards
You can select the PAL, SECAM or NTSC configuration as the TV standard for
the connected monitor. You should perform these settings according to the con-
nected monitor; otherwise, it could result in display errors.
1. Press the Menu button on the remote control.
E The menu of the IVTV-05 is displayed.
2. Move the selection mark with the M or N button to the Setup menu item and press
the OK button.
E The Setup menu is displayed.
3. Move the selection mark with the N button to the TV Configuration menu item and
press the OK button.
E The TV Configuration menu is displayed, the TV Format menu item is selected.
4. Move the selection mark with the N button to the TV output signal menu item.
5. Press the O or P button repeatedly until the desired TV standard is displayed.
6. Press the OK button.
E The Setup menu is displayed again.
7. Press the Menu button to return to the menu. Press the button again to exit the
menu.
Configuration
To Next Page
Loading...