85
Tuner mode
ENGLISH
Switching the priority of traffi c reports
on/off
The priority of traffi c reports is switched on if the
symbol appears on the display. This setting
limits the station search and scanning (SCAN) for
traffi c information stations.
To switch the traffi c report priority on/off,
press the MENU button 9.
The Tuner menu opens.
Press the rocker switch
or @ to select
the "TRAFFIC" function.
Press the OK button :.
Switch between the settings with the rocker
switch
or @.
"TRAFFIC" : Priority on.
"TRAFFIC" : Priority off.
Press the OK button : to select a different
function, or press the DIS•ESC button ; to
exit the menu.
Note:
For the device to switch through traffi c
reports, a station must be defi ned that
supports TA or belongs to a broadcasting
network with traffi c information stations.
A signal tone appears every 30 seconds if you
leave the broadcast area of the traffi c informa-
tion station or switch to a station that does not
support the traffi c information priority. In this
case, switch off the priority or tune into a traffi c
information station. If a different audio source
than the tuner is active, the device automatically
searches for a traffi c information station.
Skipping a traffi c announcement
To cancel a traffi c announcement without switch-
ing off the priority of traffi c announcements,
press the DIS•ESC button ;.
The previously active audio source is played
again. If a traffi c announcement is broadcast
again, the device automatically switches it
through again.
쏅
쏅
쏅
쏅
•
•
쏅
쏅
Receiving an alternative frequency
of a station
The device can automatically switch to the best
alternative frequency of the same station if the
reception becomes poor.
Allowing/preventing alternative frequencies
(RDS )
To switch RDS on/off,
press the MENU button 9.
The Tuner menu opens, the "RDS" function is
selected.
Press the OK button :.
Switch between the settings with the rocker
switch
or @.
"RDS" : RDS on, allowing alternative
frequencies.
"RDS" : RDS off, preventing
alternative frequencies.
Press the OK button : to select a different
function, or press the DIS•ESC button ; to
exit the menu.
Note:
For the device to switch to an alternative fre-
quency (AF) in case of poor reception, the
station must also support the RDS function
Alternative frequency (AF).
Allow/prevent changing to other regional
programmes (REGIONAL )
Some stations divide their programmes into re-
gional programmes with different contents at
certain times. You can use the REG function to
prevent the device from switching to alterna-
tive frequencies that are transmitting different
programme content.
To switch the regional function on/off,
press the MENU button 9.
The Tuner menu opens.
Press the rocker switch
or @ to select
the "REGIONAL" function.
쏅
쏅
쏅
•
•
쏅
쏅
쏅
02_NJerseyMP68_gb.indd 8502_NJerseyMP68_gb.indd 85 29.10.2008 10:59:55 Uhr29.10.2008 10:59:55 Uhr
To Next Page
Loading...
