PP15DAB
INSTALLATION
- Read the manual thoroughly before operating the device!
- Choose a suitable location for the device. Suitable locations are dry, even and anti-slip
surfaces on which you may operate the device easily.
- Make sure there is proper ventilation for the device!
POWER SUPPLY
You can use this radio player on AC power or battery power.
AC OPERATION
- Connect one end of the AC adaptor to the DC 5V jack on the back of main unit.
- Insert the grid plug into a properly installed AC socket.
- Make sure the grid voltage corresponds to the figures on the rating plate.
CAUTION:
- Only use the supplied power adaptor for this device.
- Do not use the supplied power adaptor for other devices.
Note: Disconnect from mains power supply during longer periods of non-use.
DC OPERATION
- Open the battery compartment at the back of the unit.
- Insert 4 UM-2/C size batteries (not supplied) with correct polarity (+/-) as indicated, then
close the battery compartment.
Note: The battery circuit is disconnected automatically when the AC adaptor is
connected to the main unit, then it is operated by AC.
CAUTION:
- Be sure that the batteries are installed correctly. Wrong polarity may damage the unit.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
- Only batteries of the same or equivalent type as recommend are to be used.
- If the unit is not to be used for an extended period of time, remove the batteries to
prevent damage or injury from possible battery leakage.
- Do not dispose of batteries in fire, batteries may explode or leak.
11
To Next Page
Loading...
