Setting the reception area
This car audio system is designed for
operation in different regions with different
frequency ranges and station technologies.
F In the main menu, press the [ ] button.
The Settings menu is displayed.
F Tap on the [ ] button to display the list of
available reception areas. The current
setting is highlighted.
F Select the desired reception area by
clicking.
F Press the [ ] button. The main menu is
displayed again.
Radio mode
Start radio mode
In the main menu, press the [Radio] button.
The radio playback menu is displayed.
Select memory bank
Different memory banks and wave bands are
available. Up to 6 stations can be stored in
each memory bank.
F Press the [ ] button repeatedly until the
desired memory bank is displayed.
FM1 -> FM2 -> FM3 -> AM1 -> AM2 ->
Fm1
Tuning into a station
Tuning into stations manually
F Briefly press the [t] or [u] button once or
several times to change the frequency in
increments.
Placing the device in operation
Switching ON / OFF
Switching on/off with the rotary /
pushbutton
F For switch-on, hold the [ ] button pressed
for more than 2 seconds.
F For switch-off, hold the [ ] button again.
Switching on/off via vehicle ignition
If the car audio system is connected with the
vehicle ignition and it was switched off with
the POWER button, it is switched on or off with
the ignition.
Volume
Adjusting the volume You can adjust the
volume in steps from 0 (off) to 40 (maximum).
F Press [ ] / [ ] to change the volume.
Main menu (Home)
In the main menu, you press the buttons on
the touchscreen to call up the different
sources and operating modes.
F In the current source, press the[ ] button.
The main menu is displayed.
F
[ ] Enter standby mode
[ ] Enter settings menu
[ ] Change the wallpaper
Note:
F Some sources can't be selected if the
external devices aren't ready.
F The figures used in these instructions are
intended to facilitate the explanations
and details may deviate from your device.
6
Placing the device in operation Radio mode
To Next Page
Loading...
