&/(-*4)
Tuning into a station
There are various ways of tuning into a sta-
tion.
Automatic station seek tuning
Press the
or button .
The radio tunes into the next receivable sta-
tion.
Tuning into stations manually
You can also tune into stations manually.
Note:
You can only tune into stations manu-
ally if the convenient RDS function is
deactivated.
To change the set frequency in small incre-
ments,
briefly press the
or button .
To change the set frequency quickly,
press and hold down the
or button
for a longer period of time.
*
*
*
Switching REGIONAL on/off
Press the MENU button .
Press the
or button repeated-
ly until "REG" appears on the display.
"OFF" or "ON" is displayed alongside
"REG".
To switch REGIONAL on/off,
press the
or button .
Press the MENU button .
Switching the RDS function on/off
To switch the RDS functions AF and
REGIONAL on or off,
press and hold down the
TRA•RDS but-
ton for longer than two seconds.
The RDS functions are active when RDS
lights up in the display.
Selecting the waveband/memory
bank
This device can receive programmes broad-
cast over the FM frequency range as well as
the MW and LW (AM) wavebands. There are
three memory banks available for the FM
waveband (FM1, FM2 and FMT) and one
for each of the MW and LW wavebands.
Six stations can be stored in each memory
bank.
To switch between the FM memory banks
(FM1, FM2 and FMT) and the MW and LW
wavebands,
briefly press the
BND•TS button .
*
*
*
*
*
*
Radio mode
To Next Page
Loading...
Need help?
General
