Blaze BLZ-3 - Unit Installation and Burner Setup; Unit Installation Overview; Burner Alignment and Inspection

Blaze Grills by Blaze Outdoor Products Instructional Book
20
Safety and Installation Instructions
UNIT INSTALLATION:
Your Blaze Series Grill comes pre-assembled and requires very little setup. We do however;
recommend the use of professional help during the installation of your unit as improper
installation may affect your warranty.
Remove the unit from the box along with all accessories and check that no damage has
occurred to the unit or any parts.
Burners: Check the burner tubes and remove any obstructions that may be in the ports or
holes. Using cold water and a brush will be sufficient. Make sure all foreign particles are
removed from the burner before use. Make sure the air shutter on the burners is slightly
opened (to about 1/8").
WARNING
For proper operation, burners must be aligned with the valve orifice and seated in the
bracket slot.
This is accomplished by first placing the burner tube shutter hole securely over the
valve orifice and then secure with the cotter pin at the rear of the barbecue.