Blendtec CLASSIC SERIES - SECTION 6: CARE AND CLEANING; 6.1 CLEANING AFTER USE; 6.3 CLEANING TIPS AND CAUTIONS

11
You can switch to a different speed at any point during the cycle� To stop the cycle
at any point during blending, press Stop�
PULSE
The Pulse button is used for chopping, mincing, whipping, or other momentary
tasks that do not require a long blend cycle� You can also use the Pulse button to
quickly stir a blend before serving�
The Pulse setting runs at speed 7 and will only run while the Pulse button is held
down� When the button is released, the motor shuts off�
SECTION 6: CARE AND CLEANING
6.1 CLEANING AFTER USE
1� Add 1 cup (240ml) of hot water and a drop of liquid dishwashing soap to the
blender jar�
2� Place the lid tightly onto the jar�
3� Place the blender jar on the blender base and, with your hand placed on top of the
lid, press the CLEAN cycle button�
4� Rinse well�
5� Clean the blender base by simply wiping the base and interface with a damp cloth�
6.2 LONG-TERM SANITATION
1� For long-term sanitation, fill the blender jar with hot water�
2� Add one teaspoon of liquid chlorine bleach to the FourSide jar or two tea-
spoons to the WildSide+ jar�
3� Stir for 10 seconds to mix water and bleach� Let mixture stand in blender jar for
five minutes�
4� Empty water/bleach mixture� Turn jar upside down on dish rack until dry�
6.3 CLEANING TIPS AND CAUTIONS
• Do not use stiff bristled brushes or abrasive cloths/pads to clean the blender base
or jar, as this will dull or scratch the surface�
• NEVER submerge the blender motor in water� Avoid submerging blender jars for
more than 5 minutes� Water penetration through the lower jar seals will reduce the
life of the jar� After cleaning, we recommend the blender jar be stored upright�
• BLENDER JAR IS DISHWASHER SAFE—TOP RACK ONLY! Extreme temperatures
damage the lower seal of the jar� We recommend hand washing to prolong the
life of the blender jar� We do not recommend the jar be used for temperatures
above boiling (212°F, 100°C)�