Blendtec DESIGNER SERIES - Section 6: Care and Cleaning; Blender Cleaning Procedures; Long-Term Sanitation; Cleaning Tips and Cautions

15
When blending carrot juice or other dense juices, you may need to repeat this
cycle once or twice until the desired texture and consistency are achieved�
HOT SOUP
This 90-second cycle is designed for hot recipes� The cycle’s length of time, com-
bined with the speed of the motor, heats the ingredients to a hot temperature� This
cycle can also be used for hot chocolate, syrups, and fondue�
When using fresh ingredients, remember that the speed of the blade generates
enough heat to warm the ingredients Do not add any liquids or ingredients over
115° F to the jar when preparing soups or hot items�
PULSE
The Pulse function is used for chopping, mincing, whipping, or other momentary
tasks that do not require a long blend cycle� You can also Pulse to quickly stir a
blend before serving�
The Pulse setting runs at speed 7 and will only run while the Pulse icon remains
pressed� When the icon is released, the motor shuts off�
CAPACITIVE TOUCH SLIDER
The capacitive touch slider allows you to fine-tune the speed of your blender�
Simply slide your finger to the right to increase the blender’s speed or the left to
decrease speed�
SECTION 6: CARE AND CLEANING
6.1 CLEANING
1� Add 1 cup (240ml) of hot water and a drop of liquid dishwashing soap to the
blender jar�
2� Place the lid tightly onto the jar�
3� Place the blender jar on the blender base and, with your hand placed on top of the
lid, press the CLEAN cycle button�
6.2 LONG-TERM SANITATION
1� For long-term sanitation, fill the blender jar with hot water�
2� Add one to two teaspoons (5-10ml) of liquid chlorine bleach to the jar�
3� Stir for 10 seconds to mix water and bleach� Let mixture stand in blender jar
for five minutes�
4� Empty water/bleach mixture� Turn jar upside down on dish rack until dry�
6.3 CLEANING TIPS AND CAUTIONS
• Do not use stiff bristled brushes or abrasive cloths/pads to clean the blender base
or jar as this will dull or scratch the surface�
• NEVER submerge the blender motor in water� Avoid submerging blender jars for
more than 5 minutes� Water penetration through the lower jar seals will reduce the
life of the jar� After cleaning, we recommend the blender jar be stored upright�