Need help?Do you have a question about the Blendtec BD8 and is the answer not in the manual?
Details safety and health certifications for the BD8 models.
Lists critical safety measures to prevent injury and damage during operation.
Outlines precautions for using the power cord and avoiding electrical hazards.
Advises on proper operational practices, including handling, attachments, and door closure.
Specifies voltage, wattage, amperage, and recommended receptacles for BD8 models.
Warns against circuit overloading and improper cleaning methods.
Introduces the BD8 blender dispenser and its key benefits for high-volume operations.
Describes the main parts of the BD8: the Blend Station, Control Board, and Water Input Line.
Lists the available voltage models for the Blendtec BD8 blender.
Details required spacing and location considerations for optimal counter placement.
Refers to power requirements for proper electrical hookup of the unit.
Explains necessary water line fittings, pressure, and filtration for installation.
Describes how to connect the product lines to the unit's inlets.
Step-by-step guide on how to prepare drinks using the BD8's programming.
Explains how to dispense product only, water only, or run the blender motor.
Outlines tasks for cleaning the unit and jar after each use and on a short-term basis.
Provides instructions for cleaning blender jars for both short-term and long-term care.
Details monthly sanitizing procedures for the blend station and product tubes.
Explains two methods for cleaning and sanitizing the product lines and tubes.
Explains how ingredient ratios, temperature, and thickness affect smoothie results.
Instructs how to access and navigate the programming mode for settings adjustments.
Guides on modifying product quantities for specific drink recipes.
Details how to set and adjust the water dispense rate for drinks.
Explains how to program the duration for each blend cycle.
Guides on selecting and setting up pre-programmed blend cycles for optimal results.
Describes how to set pause durations between blend actions for ingredient settling.
Explains how to define and set the S, M, and L drink sizes and their ratios.
Details the process for calibrating pumps to ensure accurate product dispensing.
Explains how to measure and set the correct water flow rate for drinks.
Allows selection of the default drink size mode after a drink is made.
Describes how to reset drink settings, blend cycles, and misc. settings to factory defaults.
Explains how to lock the machine or specific alcohol pumps to control usage.
Details options for tracking total machine, individual, and total drink counts.
Allows users to customize up to six blend cycles with specific speeds and times.
Provides solutions for the machine not running or the blender stopping unexpectedly.
Addresses common issues like runny drinks, thickness, cavitation, and lack of flavor.
Solves problems related to flavor intensity, ice chunks, water dispensing, and product leaks.
Explains how to contact Blendtec for warranty repairs and service options.
Provides contact information for troubleshooting or replacing blender jars.
Outlines procedures for obtaining paid repair services for the unit.
A template for recording and planning drink recipes, including pump, water, and blend settings.
Confirms the correct placement and proximity to utilities for the unit.
Ensures adequate clearance around the unit for proper installation and operation.
Verifies if the unit is installed near a sink for water connection convenience.
Checks if the water source meets all specified connection and pressure requirements.
Specifies the need for an in-line filter and recommends plumbing configurations.
Confirms that power requirements, circuit usage, and surge protection are met.
Ensures the ice machine is installed and ready for operation.
General| Manufacturer | Blendtec |
|---|---|
| Model | BD8 |
| Blade Material | Stainless Steel |
| Voltage | 120 V |
| Motor Power | 3.8 HP |
| Power | 1800 W |
| Jar Capacity | 90 oz |
To Next Page