19
keypad.
• Enter the Alcohol Pump lockout code; the factory default is 0, and press GO.
The screen will read “Pump 6 Unlocked” or “Pump 6 Locked”. It can then be
changed to the other by either pressing the S or the M, then press GO.
• The screen will now read “Pump 7 Unlocked” or “Pump 7 Locked”. Make a
selection by using the S or M button and then press GO again to make a
selection.
• The screen will now read “Pump 8 Unlocked” or “Pump 8 Locked”. Make a
selection by using the S or M button and then press GO again to make a
selection.
• Once the pumps have been configured, the menu can be exited by pressing
the STOP button.
• To change the alcohol pump lockout code enter 3-5-2-GO on the keypad.
• The screen will then read “Enter Acode:”. Enter the current code (the factory
default is 0) and press GO.
• The screen now reads “New Acode:”. Enter new code (up to four digits) and
press GO.
• The screen then reads “Re-Enter:”. Re-enter the desired code and press GO.
• Press the STOP button twice to exit the menu.
7.6 Drink Counts:
• The following options allow the user to maintain counts of the individual
drinks made by day and total for lifespan.
• Total Machine Count: To access the machine count, press 8-0-0-GO. The
machine count will be displayed. (If the number of cycles has exceeded
65,535 cycles then there will be a multiplying counter that is displayed also.
The multiplying counter will increment each time the machine count reaches
65,535 and resets to 0.) To exit the machine count screen press STOP twice.
This count cannot be reset.
• Individual Drink Counts: Each time a Drink Cycle is run a respective count
will be incremented. This count can be viewed by pressing 8-0-1-GO. The
screen will read “Drink # 1 ____”. Use the M button to increment the Drink
number and use the S button to decrement the Drink number. Using the
8-0-3-GO feature can clear these counts.
• Total Drink Count: A total of all of the individual drinks can be viewed by
pressing 8-0-2-GO. This total count is reset to zero when the 8-0-3-GO
feature is executed.
• Clear Drink Count: By pressing 8-0-3-GO, all of the individual drink counts
are cleared as well as the Total Drink Count. After pressing 8-0-3-GO, the
screen reads “Clear Counts?” Press GO to confirm that the Counts should
be cleared.
7.7 Advanced Blend Cycle Control
This feature allows the user to customize up to 6 blend cycles.
• Press 7-9-0-GO to access the Blend Cycle Menu.
• The first thing that appears on the screen is “Cycle 1 Speed A: 0”.
• From this point use the S, M, L, and Go buttons to navigate to any of the
parameters in the Blend Cycle. S will decrement the Blend Cycle number,
To Next Page
Loading...
