18
vert To Same”, and “Revert To None”.
• Press the S or M button to scroll through the three options.
• Once you have the option you want selected press STOP. The setting
you have selected will be stored.
7.4 Restore Defaults:
• There are three types of restore defaults: Drink Settings, Blend Cycles,
and Misc. Settings. These three will revert key settings back to the factory
default. If you do not have a profile that is installed at the factory then the
default settings will revert to “0”.
• Restore Drink Settings: This feature will restore the Drink Settings to their
factory defaults. Press 4-4-4-GO and the screen reads “Reset Drinks?”.
• Press GO again to confirm that the drink settings should be reset to the
defaults. The screen will say “Storing Drinks” and a count will show the
progress.
• Restore Blend Cycles: This feature will restore the Blend Cycles to their
factory defaults. Press 4-4-5-GO and the screen reads “Reset Cycles?”.
Press GO again to confirm that the Blend Cycles should be reset to the
defaults. The screen will say “Storing Cycles” and a count will show the
progress.
• Restore Misc Settings: This feature will restore various settings to their
factory defaults. Press 4-4-6-GO and the screen reads “Reset Settings?”.
Press GO again to confirm that the settings should be reset to the defaults.
The settings that will be reset to factory defaults are: Clutch Heater will
revert to off, Size Default will revert to Small, Drink Size options will revert to
12oz, 18oz, and 24oz, the Pump Cube Sensor reverts to off, and the Sanitize
Lockout reverts to off.
7.5 Locking the Machine:
• This feature allows the manager/owner to lock the machine out of use by
other employees without the use of a code. The manager/owner can decide
and change the lockout code at will.
• Change or set machine lockout code: Enter 7-7-8-GO on the keypad.
The screen will then read “Enter Code:”. Enter the current code (the factory
default is 0) and press GO. The screen now reads “New Code:”. Enter new
code (up to four digits) and press GO. The screen then reads “Re-Enter:”
Re-enter the desired code and press GO.
• Lock Machine: To lock the machine press 7-7-7-GO. This will disable all
functions. The screen will say “Enter Code:”. The machine will not work until
the correct security code is entered and the GO button is pressed.
• Write your code down and hide it in case you forget. If you do forget your
code and cannot find where you have it written down call Blendtec Technical
Support for assistance at 800 748-5400, ext. 494 or 248.
• Alcohol Pumps: If your machine was set up to include alcohol pumps you
can lock them specifically. This feature allows pumps 6, 7, and 8 to be
locked so that product cannot be dispensed by using the JUICE button. The
factory default is such that Pump 6, 7, and 8 are all unlocked. You can also
change the code that locks/unlocks the pumps.
• They can be locked or unlocked individually by entering 3-5-3-GO on the
To Next Page
Loading...
