9
water, and then blend. All parameters for drink production can be manipulated
to suit your needs (see Section 6).
4.2 Dispense Product Only:
You can dispense product only by pressing the number of the pump (1-8) and
then pressing and holding the JUICE button. The unit will dispense the product
selected until you release the JUICE button. The maximum time that the JUICE
button will dispense is 25 seconds. This feature allows you to prime your prod-
uct lines easily with little waste.
4.3 Dispense Water Only:
By pressing and holding the WATER button you can dispense cold water as
desired. The maximum amount of time the feature will run is 25 seconds.
4.5 Run Blender Motor Only:
This feature can be used in two ways: as a ramp pulse (gradually increasing
speed) or to run at a constant speed. To use as a ramp pulse, press and hold
the BLEND button until the drink is completed. The motor will stop when the
BLEND button is released. To run at a constant speed, select the speed (1-9)
and then press and hold the BLEND button. The unit will run until the BLEND
button is released or for 25 seconds.
Section 5: Cleaning and Sanitizing
5.1 After Each Use:
After every use of the unit, the operator should ensure that the blender jar has
been rinsed, the blend station has been wiped out if there is spillage, and that
the blender door is wiped down if there is spillage. ALWAYS keep an empty jar
on the blender motor base when the unit is not in use. This helps catch any
potential drips and keeps liquid from leaking into the blender motor.
5.2 Jar Care:
SHORT TERM – as needed, wash the jars with a mild detergent solution. Do
not immerse the jars for longer than necessary in any type of liquid. Wash
quickly with a smooth cloth or sponge, rinse, and sanitize with appropriate solu-
tion. (Some sanitizer manufacturers require their sanitizer to remain in contact
with the sanitized object for a specific amount of time before rinsing or remov-
ing. Refer to your manufacturer’s instructions before rinsing.) Hold the jar by
the handle and give three or more sharp downward shakes to remove any water
from around the shaft area. Then place the jar upside down on a rack to dry.
LONG TERM – As needed, fill the jar with hot sanitizer solution. Stir and let set
for 5 minutes. Empty and rinse with clear hot water. Hold the jar by the handle
and give three or more sharp downward shakes to remove any water from
around the shaft area. Then place the jar upside down on a rack to dry.
5.3 Short Term (Unit):
As time permits (daily or weekly), wipe down the exterior of the unit and the
interior of the blend station with a damp rag. Carefully tilt the machine either
backward or forward (two person operation) and wipe underneath the unit with
a damp rag.
To Next Page
Loading...
