2
Attach the mill to pan and make
sure grain is clean
Mill Motor
with Gasket
Assembly
Mill Pan
With the cyclone cup in place, turn the mill right side up and place it on the mill pan. Latch one
side at a time. Make sure the latches snap over the edge of the pan. After latching the sides in
place, push down on the top to make sure the mill and the pan are snugly together.
Note: BE SURE TO USE ONLY CLEAN GRAIN. Hard foreign objects like nails and other
pieces of metal can cause severe damage to the mill. This type of damage is not covered
by the warranty. Inspect your grain to make certain it is clean before milling. Make sure the
power cord is plugged into a grounded receptacle.
4
To Next Page
Loading...