Page 8 of 9
Within a short time the BlipNode L2i will connect to the internet through the
modem. You can see the connection status on the Yellow LED on the BlipNode L2i and on the
flashing LED on the USB modem as described in the USB modem User’s Manual (on the modem you
can e.g. see the connection speed)
Before returning a defect product
If the left most LED (green) is on, and no other LEDs are on or blinking it is very likely that the
processor-board inside the BlipNode has come loose of its connector (you can locate the processor
board as the board hanging above the main board).
Turn off the power and insert the board.
Contact BLIP Systems before returning any products.
To Next Page
Loading...