Operating instructions
Transport and storage
102620 • 05/2019
2 Transport and storage
2.1 Transport
Danger
Mortal danger caused by incorrect
transport.
Never lift the compressor by the fan
cover.
Only use suitable lifting gear with the
corresponding weight-bearing capacity
(for data on weight, please refer to
chapter “Technical annex”).
Fasten and secure the system with
belts at the corresponding points.
Secure swivelling and loose parts.
Transport the compressor by means of
crane hooks, fork-lift truck and elevat-
ing truck only.
Never remain under suspended loads.
Depressurise the compressor prior to
any transport.
2.2 Storage
Store the compressor in a dry location pro-
tected against weather influence. Ambient
temperature: -10° C to +50° C.
Please order the BLITZ conservation instruc-
tions in case of storage of over six months.
3 Mounting
3.1 Mounting conditions
Check the compressor for damage during
transport.
Ambient conditions
Danger
Mortal danger and explosion hazard
when caustic, inflammable or poison-
ous gases are drawn in.
Do not operate the compressor in ex-
plosive surroundings or in the vicinity
of open flames and flying sparks.
Caution
Wrong mounting will cause damage to
the compressor.
Ensure sufficient ventilation of the
compressor room.
Do not operate the compressor in the
open.
The space between the compressor and the
wall has to be at least 40 cm (cf. Fig. 2: Loca-
tion). The compressor has to be easily acces-
sible from all sides. The ambient temperature
has to be between 5° C and 40° C.
Abb. 2: Location
Ground
Place the compressor on a horizontal and
plane surface.
The ground has to have a suitable load-
bearing capacity. BLITZ offers special solu-
tions for inclined surfaces.
BLITZ recommends the use of rubber-metal
connections to prevent vibrations.
Transport and storage, mounting
To Next Page
Loading...