Self-Contained Ice Maker User Manual for Installation and Maintenance
is flowing evenly on the evaporator.
✓ The compressor is running normally, the
temperature of the evaporator and the ice
making water is gradually decreasing.
✓ The fan is running normally, and there is
stable air flow in the inlet and outlet of the
ice machine.
✓ The ice machine has no abnormal noise.
✓ The ice machine has no abnormal
vibration.
✓ It takes about 10 to 20 minutes to make
one batch ice, depending on the ambient
temperature and the temperature of the
water. The higher the temperature is, the
longer the ice making will take.
✓ Ice cube can be properly defrosted from
the machine.
Operation Instruction
Startup: after proper installation, connect
the water source and turn on the power
supply, the machine will start working.
Please confirm that the machine is
operating normally when you turn it on for
the first time.
Note: In case of thunderstorm or not
in use for a long time, please disconnect
the power and water source!
Self-check: with power on for the first
time, the ice maker will do self-check and
pump out remaining water.
Preparing: after the ice machine is
energized, the inlet valve opens, and the
inlet water will flow in until it reaches the
set level; then the ice maker will do
defrosting one time.
Ice making: after pre-cooling for 30
seconds, the water pump starts, the water
flows through the evaporator smoothly
and evenly, the ice cubes are gradually
formed in the ice cube tray.
Ice Harvest: after the ice making process,
the water pump is turned off, the
defrosting valve is turned on, and after
the hot gas enters into the evaporator for
about 1-2 minutes, the ice cubes slide
from the evaporator into the storage bin.
Warning: Do not put your hand into the
ice storage bin during the ice-falling
process to prevent the ice from hitting
your hand!
Shutdown: The ice maker will stop
working when you click the “on/off” button
on the panel during running process.
Bin full stop: in the running state, with
the storage bin filled to a certain height,
the ice sliding board cannot be rebounded
or reset because of the block of the
freshly produced ice cubes, the ice maker
will stop in 30 seconds.
Repeat ice-making: when the ice cubes
on the ice sliding board are taken away,
the ice maker will back to ice making
process in a few seconds.
To Next Page
Loading...