44
Power supply
› Plug the power cable into a correctly installed power outlet of your public power system.
Antenna
› Connect the tuner antenna connector to the „Tuner Antenna” connection on the back of the device.
Signal output
› Connect these jacks to the respective jacks found on your amplifer. Ensure that connections
have been made properly (this normally means red to red and white to white).
Network
› A RJ45 cable is used to connect the LAN connection on the device to your router.
W-LAN
› For wireless operation, attach the antenna to the „Wi-Fi 2.4G Antenna“ connection. Your pass-
word may be required for the wireless network.
Chapter 4 Connection
4
Connection
-
To Next Page
Loading...
