Blomberg LDV02284 - Installation; Appropriate Installation Location; Connecting Water Supply

Dishwasher / User manual
9 / 44
EN
3
󰀬
To make the product ready for use,
make sure that the electricity, tap
water supply and water drainage
sy󰀬ems are appropriate before calling
the Authorised Service Agent. If they
are not, call a qualied technician
and plumber to have any necessary
arrangements carried out.
C
Preparation of the location
and electrical, tap water and
wa󰀬e water in󰀬allations
at the place of in󰀬allation
is under cu󰀬omer's
responsibility.
B
Manufacturer shall not
be held responsible for
damages arising from
processes carried out by
unauthorised persons.
A
Prior to in󰀬allation, visually
check if the product has any
defects on it. If so, do not
have it in󰀬alled. Damaged
products cause risks for your
safety.
C
Make sure that the water
inlet and discharge hoses
are not folded, pinched or
crushed while pushing the
product into its place after
in󰀬allation or cleaning
procedures.
When placing the product, pay attention
not to damage the oor, walls, piping,
etc. Do not hold the product from its
door or panel to move it.
󰀬

• Place the product on a solid and
at oor that has su󰀩cient load
carrying capacity! The product
mu󰀬 be in󰀬alled on a at surface
in order for the door to be closed
comfortably and securely.
• Do not in󰀬all the product at places
where temperature may fall below
0ºC.
• Place the product on a rigid oor.
Do not place it on a long pile rug or
similar surfaces.
B
Ensure the power cable does
not get trapped under the
product.
• Make sure that you select a
location that will allow you to load
and unload the dishes in a fa󰀬 and
comfortable manner.
• In󰀬all the product in a place close
to the tap and the drain. Select the
in󰀬allation location by considering
that it will not be changed after the
connections are made.

• Do not use old or used water inlet
hose on the new product. Use the
new water inlet hose supplied with
the product.
• Connect the water inlet hose
directly to the cold water tap.
Permitted water temperature up
to 25°C. Pressure coming from
the tap should be minimum 0.3
and maximum 10 bars. If the
water pressure exceeds 10 bars,
a pressure relief valve should be
in󰀬alled in between.
• Open the tap completely after
making the connections to check
for water leaks.