What to do if my Blomberg WAF 1200 won't turn on or start a program?
If your Blomberg Washer isn't turning on or starting a program, ensure a program has been set and the Start/Pause button has been pressed. Check that the loading door is properly closed by pushing it until it locks. Also, verify that the power cable is plugged in and the fuse for the socket is intact.
What to do if my Blomberg WAF 1200 Washer is not draining water properly?
If your Blomberg washer isn't draining water or is draining very slowly, check if the Rinse hold is set. Also, inspect the drain hose to ensure it is not kinked.
Why is my Blomberg Washer not spinning properly?
If your Blomberg washer isn't spinning properly or at all, check if Rinse hold is set. Also, verify that the spin speed isn't set too low or deselected, and ensure the load is distributed uniformly inside the drum.
What to do if my Blomberg WAF 1200 door won't open?
If the door of your Blomberg washer won't open, check if the program is finished. The door can be opened when the >Door< indicator lamp goes out.
Why is my Blomberg WAF 1200 Washer leaking water?
If your Blomberg washer is leaking water, check if the hoses are properly attached. Also, make sure the foreign matter trap is securely closed and that excessive detergent use isn't causing too much foam.
Why is my Blomberg Washer vibrating so much during spinning?
If your Blomberg washer vibrates heavily when spinning, ensure the transport locks have been removed. Check that the machine is properly positioned and leveled. Also, make sure the drain hose is not kinked, as this can prevent water from draining properly.
Why is the >No water intake< indicator lamp glowing on my Blomberg Washer?
If the >No water intake< indicator lamp is glowing on your Blomberg washer, ensure the water tap is fully open. Check the inlet hose for any kinks and inspect the water inlet strainer for clogs. Also, verify that the water pressure is not too low and that Aquasafe or Aquasafe+ hasn't been activated due to leakages.
Why is the softener compartment in my Blomberg WAF 1200 full of water?
If the softener compartment (middle compartment in the detergent dispensing drawer) is full of water at the end of a program, the siphon may be clogged.
What to do if my Blomberg WAF 1200 Washer stops during a power failure?
If there is a power failure during a wash cycle, and the power failure is temporary, the appliance will automatically continue the wash program when the power supply is restored. If the power failure is going to be long and you need to drain the leftover water, see "Cleaning and care".
Why is my Blomberg WAF 1200 Washer not reacting to input?
If your Blomberg washer is not reacting to input, it may be due to a combination of additional functions not being possible or the Child-proof lock being activated. It could also be that a time delay has been set. If the problem persists, pull out the mains plug, wait a few seconds, and reinsert it.
Specifies the appliance's intended purpose and limitations for washing, rinsing, and spinning textiles.
Outlines crucial safety precautions for electrical connection, handling, and maintenance.
Provides essential safety guidelines for households with children present.
Step-by-step instructions for removing transit bars before operation.
Advice on selecting the right location and adjusting feet for stability.
Instructions for connecting the water inlet hose, including safety notes.
Guidance on how to connect the drain hose to a suitable outlet.
How to secure the drain hose and connect the appliance to mains power.
General| Type | Freestanding |
|---|---|
| Load Type | Front Load |
| Maximum Spin Speed | 1200 RPM |
| Spin Speed | 1200 RPM |
| Dimensions (H x W x D) | 85 x 60 x 54 cm |
To Next Page