BLUEBOT EZ1 - Filter Cleaning and Replacement; Mopping Module and Water Tank Care

16
mAiNTeNANce
FILTER | REGULAR CLEANING
1 Remove the primary lter, sponge and HEPA.
2 Clean the removed primary lter, sponge, and HEPA with water if needed.
3 Shake o the water drops and dry the pieces naturally, then use them after
they have completely dried.
4 When dry, install them in the sequence: HEPA > sponge > primary lter.
MOPPING MODULE | 2 IN 1 ELECTRICALLY-CONTROLLED WATER TANK
1 Remove the mop, empty the water tank after each use.
2 Clean the mop (by hand or in a washing machine; max 40°C), dry naturally, do
not tumble dry the mop. Dry the water tank naturally by air.
Primary lter
Sponge
HEPA
Water tank