English BlueCard
Status Indications
BP-2002S
1 Beep With 4 Flashes
Reading is successful.
After Reading a Card, 4 Beeps With 4 Flashes
The reading was not successful. The reader memory is full, the data needs to
be uploaded before more readings can be made.
After Reading a Card, 1 Beep With 4 Flashes, Followed By 4 Beeps With 4
Flashes
The reading was successful, but the reader’s internal clock should be
calibrated with the PC before further readings are made.
After Reading a Signal Card, The LED Light Flashes Continuously
The battery is low and needs to be changed.
After Reading a Signal Card, 1 Beep with 4 Flashes Followed by 8 “Beep”
Sounds With 8 Flashes of the LED
There is an error within the reader. It needs to be connected with the computer,
have its data uploaded, then initialized.
BP-2002F
A display of the current time.
(If a card reading has just been made, is accompanied by 4 beeps
with 4 flashes of the LED.) The reader’s memory is full. It needs to upload its
data before further readings can be performed.
(If reader makes 4 beeps with 4 flashes of LED, when the reader
just has been turned on.) The reader’s internal clock needs to be calibrated
with the PC before further readings can be made
After Reading a Signal Card, The LED Light Flashes Continuously
The battery is low and the reader needs a new battery.
After Reading a Signal Card, 1 Beep with 4 Flashes Followed by 8 “Beep”
Sounds With 8 Flashes of the LED
There is an error within the reader. It needs to be connected with the computer,
have its data uploaded, then initialized.
To Next Page
Loading...