bluelab Guardian Monitor Wi-Fi User Manual

English
7
9.0 Connect Guardian Monitor to Wi-Fi for the first time
To connect the device to Wi-Fi, it is helpful to have the onboarding QR code available for
scanning. This can be found on the back of the device or on the packaging.
Have the security code QR image handy.
When first powered on, the Guardian Monitor Wi-Fi automatically starts in Provisioning mode.
This allows Wi-Fi settings to be configured from a mobile device. Once the Guardian Monitor
has been connected to a Wi-Fi network it will no longer start in Provisioning mode. If you need
to connect to a new network see section 10.
1. Ensure Bluetooth is enabled on your mobile device and the Edenic app is installed.
2. Open the Edenic app on your mobile device and log in.
3. Remove the power cable for a few seconds then reconnect.
4. In the Edenic app, click the add device button in the bottom right.
5. Select scan a QR code.
6. Scan the QR code provided on the back of your Guardian / packaging.
7. Enter a device name to help you recognise this Guardian Monitor.
8. Wi-Fi details – Click the view Wi-Fi networks to see available networks.
9. Select the Wi-Fi network you want to connect to.
10. Enter the Wi-Fi network password.
11. Select continue, your device will now be ready and connected.

bluelab Guardian Monitor Wi-Fi Specifications

General

Brand	bluelab
Model	Guardian Monitor Wi-Fi
Category	Measuring Instruments
Language	English