Thank you for purchasing this product. We will be very pleased if you visit our website
www.pd-cf.com and leave your review on the product page.
PCB interface assembly instructions for
Bluesound Node 2/2i.
Remove the rear cover by pulling it at the
indicated places.
Remove top two indicated screws.
Lift the upper part of the housing by tilting it
only from the back of the device, until you
hear loud "clicks". Then lift it upwards, being
careful not to break the tapes and cables.
Put the upper case carefully next to it. Do not
disconnect cables, the sockets are secured
with adhesive.
To Next Page
