LISTEN TO AM/FM RADIO
1. Press the FUNCTION button (17) to the RADIO setting. The current radio station will
be shown on the LCD Display (9).
2. Press the STOP / BAND button (3) to your desired setting (AM or FM).
3. Use the NEXT / F.FWD (2) or PREVIOUS / F.REV (1) button to select the desired
Radio station.
• TIPS FOR BEST RECEPTION
o The AM antenna is built-in to the cabinet of this player. To improve
reception of radio stations simply move the entire player to another
location until reception improves.
o
The Telescoping Antenna (27) can be adjusted for FM reception.
When listening to a FM station fully extend the antenna and slowly rotate
it until reception improves.
SETTING RADIO PRESETS
This unit can store 20-FM & 20-AM radio stations in the Preset memory. To store preset
stations follow the steps below.
1. Use the NEXT / F.FWD (2) or PREVIOUS / F.REV (1) button to select the desired
Radio station to be programmed.
2. Press the PLAY MODE / PROGRAM button (7) “P01” will begin flashing in the LCD
Display (8)
3. Use the FOLDER / MEMORY Knob (14) to set the desired Preset number (1-20).
4. Press the PLAY MODE / PROGRAM button (7) to enter the radio station into the
P
reset memory.
5. Repeat steps 1-4 to enter additional radio stations into the Preset memory.
To tune directly to your Radio Presets simply use the FOLDER / MEMORY knob (14) to
cycle through the Presets stored in the memory.
USB PLAYBACK
This unit can play MP3 files from a USB flash drive.
1. Insert a USB flash drive into the USB Port (10)
2. Press the FUNCTION button (17) until the LCD Display (9) shows “USB”. The unit
will automatically start reading the files stored on the USB flash drive. When reading
has completed the total number of songs on the USB flash drive will be shown on the
LCD Display (9).
3. Press the PLAY / PAUSE / FM STEREO button (5) to start playing your MP3 files.
• NOTE: if you have MP3 files stored in
multiple folders on your flash drive you can
use the FOLDER / MEMORY Knob (14) to cycle through the individual folders.
Each time you adjust the FOLDER / MEMORY Knob (14) the unit will skip to the
next folder on the flash drive.
CASSETTE PLAYBACK
1. Press the FUNCTION button (17) until the LCD Display (9) shows the “TAPE”
setting.
2. Press the CASSETTE STOP / EJECT button (23) to open the Cassette Door (18).
3. Insert a cassette so the tape side of the cassette is inserted into the bottom of the
Cassette Door (18).
4. Gently push the Cassette Door (18) inward until it fully closes.
5. Press the CASSETTE PLAY Button (20) to begin playback.
a. To REWIND the cassette press the CASSETTE REWIND button (21)
b. To FAST FORWARD the cassette press the CASSETTE FAST FORWARD
butt
on (22)
To Next Page
Loading...