9.4 Power Lifting Mode
The Power Lifting Mode is specifically designed to handle resistive loads up to 3,600W,
including electric blankets, kettles, hairdryers, and other heating devices. To enable it,
access the Setting Mode, navigate with the DC Power Button until the appears, and
press the AC Power Button to enable the mode.
Note: The Power Lifting Mode is not enabled by default and is only suitable for resistive
loads with a power rating between 2,400W-3,600W.
Although the AC200L can handle higher power demands, its actual operating power
remains at 2,400W.
9.5 ECO Mode
The AC200L has three ECO modes that help you save power and extend battery life:
• AC-ECO Mode
In this mode, if the AC power output falls below a certain level for a set period of time, the
AC power will automatically turn off.
Note: This mode is not available when the AC200L is charging from an AC source like a
wall outlet or generator.
• DC-ECO Mode
In this mode, if the DC power output falls below a certain level for a set period of time, the
DC power will automatically turn off.
Attention:
• The AC-ECO and DC-ECO modes are enabled by default to save energy, and it's
recommended to keep them enabled at all times.
• Use the BLUETTI App to enable or disable AC-ECO Mode and DC-ECO Mode separately.
If you use the LED screen, they'll be turned on or off at the same time.
• To avoid any interruption in charging, disable ECO Mode when charging a small device
that consumes less than 60W of power.
In the Setting Mode, press the DC Power Button to navigate through the setting items.
When the icon flashes on the screen, press the AC Power Button to enable or disable
the ECO Mode.
JUST POWER ON 21
EN
To Next Page
Loading...
