3
EN
Using the installation instructions
Please read the installation instructions and safety information before
SERVO-DRIVE start-up�
We recommend that you use the orientation diagram for easier identi-
fication of the parts being described�
These installation instructions can be used for the SERVO-DRIVE
electric motion support system for AVENTOS HF, AVENTOS HS,
AVENTOS HL and AVENTOS HK�
However, only AVENTOS HF is shown as an example in the illustra-
tions�
Please see the special AVENTOS installation instructions for the
assembly steps for the mechanical AVENTOS HF, HS, HL and HK
fittings without SERVO-DRIVE�
Intended use
SERVO-DRIVE supports the opening and closing of lift systems and
may only be used under the following conditions:
• in dry, enclosed rooms
• in combination with AVENTOS lift systems from Julius Blum GmbH
within the permitted technical specifications
• in combination with a Blum plug-in transformer�
➢ The total cable length of 2 metres must not be exceeded�
NOTE
To Next Page
Loading...
