BLUM SERVO-DRIVE uno - Assembly; Adjustment

✓✓
75°
p
p
NBY
1
6
5
4
3
2
9
AVENTOS HF / HS / HL / HK
AVENTOS HF / HS / HL AVENTOS HK
EN
Distribution cable assembly and connecting node assembly
Drive unit adjustment
SERVO-DRIVE for AVENTOS
Drive unit assembly
➢ Before SERVO-DRIVE for AVENTOS assembly, the lift mechanisms
must be set so that the front remains open in different positions�
➢ If required, install the opening angle stop only after drive unit assembly
and before the reference run�
NOTE
➢ The telescopic arm and/or lever arms must be in the completely open
position for drive unit assembly�