16
E
F
Reset Motion
Reset Wireless
Replacing the SERVO-DRIVE switch battery
Cover cap assembly
Press the <Reset Motion> button using a pen
(for at least 3 seconds) until the LED display flashes quickly�
Press the <Reset Wireless> button using a pen
(for at least 3 seconds) until the LED display flashes quickly�
Resets the reference run and enables a new reference run to be
started�
Deactivates all functions: all activated SERVO-DRIVE switches of the
respective drive unit are deactivated�
➢ Open the SERVO-DRIVE switch and
remove the battery�
➢ Insert the new battery (type CR2032)
and close the SERVO-DRIVE switch
– note proper pole connection�
When the battery power begins to weaken, the battery display (LED) will begin to flash red�
➢ The SERVO-DRIVE switch battery must not be recharged or discarded into fire�
NOTE
To Next Page
Loading...
