5
EN
• Maintain the safety distances to the Blum plug-in transformer that
are listed in the installation instructions�
• Make sure that there can be no ingress of moisture into the Blum
plug-in transformer and drive unit�
• Before starting repair or maintenance work, switch off the outlet
to which the Blum plug-in transformer is connected or pull out the
mains plug�
• The drive unit, Blum plug-in transformer and SERVO-DRIVE switch
should only be cleaned with a damp cloth because ingress of mois-
ture and aggressive cleaning materials
can damage the electronics�
• Do not touch the area around the lever during the opening and
closing motion�
• No damaged parts should be used�
• Sharp edges may damage the cables�
• Neither the Blum plug-in transformer nor any cabling should come
into contact with moving parts�
• Never take apart a drive unit or a SERVO-DRIVE switch�
• Only one drive unit may be used per Blum plug-in transformer�
WARNING
Danger of death from electric shock!
➢ Never open a Blum plug-in transformer�
WARNING
There is a danger of injury if the lever springs
upwards.
There is a danger of injury from the lever springing
upwards when the front is removed�
➢ Do not push down on lever arm, remove it
instead�
➢ Do not connect the plug-in transformer to the
power supply while the fronts are unattached�
To Next Page
Loading...
