BMC M1 Mini User Manual

M1 Mini User Manual
10 / 32
DC Inlet
Fig. 10-3
Name
Function
DC Inlet
An inlet for the DC power supply.
11. First Time Setup
11.1 Download LightTrip App software
Search and download LightTrip App in the App store.
Support Android platform and IOS platform.
11.2 Placing the Device
Place the device on a firm, flat surface. The anti-skid pad installed at the bottom of the device
is convenient for fixing the device.
WARNINGS!
• If the device has been dropped or mishandled, if the enclosure is broken, or if water has
entered the enclosure, disconnect the power cord and discontinue use. Contact your home
care provider immediately.
• If the room temperature is warmer than 95°F (35°C), the airflow produced by the device may
exceed 109.4°F (43°C). The room temperature must be kept below 95°F (35°C) while the
patient uses the device.
CAUTIONS!
• If the device has been exposed to either very hot or very cold temperatures, allow it to adjust
to room temperature (20°C, approximately 2 hours) before beginning setup.
• Make sure the device is away from any heating or cooling equipment (e.g., forced air vents,
radiators, air conditioners).
• The device is not suitable for use in high humidity environments. Make sure that no water
enters the device.

BMC M1 Mini Specifications

General

Category	Medical Equipment
Pressure Range	4-20 cmH2O
Type	CPAP
Weight	0.8 kg
Humidifier	Integrated
Power Source	AC power adapter, optional battery pack