M1 Mini User Manual
12 / 32
Fig. 11-3
WARNINGS!
• The device is powered on for use when the power adapter is connected. The Button
turns the blower On / Off.
• Use of the device at an AC voltage beyond the stated range (see Section 5 "AC Power
Consumption") may damage the device or cause device failure.
• Do not place the device where it is difficult to disconnect the power supply.
• Do not stack too long cables or tubing at the head of the bed, which may entangle the head
or neck of the patient during sleeping.
CAUTION!
• Inspect the cord of power adapter often for any signs of damage. Replace a damaged power
adapter immediately.
IMPORTANT!
• After interruption and restoration of the power supply, the device will restore its
pre-interruption working status automatically.
11.5 Assembling the Tubing and Mask
(1) Connect one end of the tube to the air outlet of the main device, as shown in Fig. 11-4.
To Next Page
Loading...
