Service Manual for RESmart
®
Auto CPAP V1.1
13/16
2
Put spring on each of three poles on heater
plane.
3
Assembly the scaleboard on the heater plane
and fix by screw (3mm*8mm).
Scaleboard
4
As per Table 3, assembly heater PCBA and
wires.
5
Put the humidifier inner connector on the
shield.
6
Put on light window.
7
Assembly the inner and outer shield.
8
Fix on screw (M3*10mm).
Appendix B:
Spare Part Configuration
S/N Name Qty Figure
1 Shield Cover 1
2 Handle 1
3 Handle Fixing 2
4 Shield Bottom 1
To Next Page
Loading...
