H60 Heated Humidifier User Manual V2.0
7 / 21
chamber base, and pour any remaining water out of the main body of the water chamber.
Undo the Water Chamber Buckle, and open the water chamber as shown below.
Fig. 4-10
CAUTION!
• Empty and air-dry the water chamber when the humidifier is not in use.
(3) Assemble the water chamber: Place the main body of the water chamber on a level
surface, and then insert the chamber base into the main body of the water chamber and
fasten the Water Chamber Buckle, as shown in the figure below.
Fig. 4-11
If the sealing loop on the bottom of the water chamber falls off, it should be installed by
aligning the groove of the sealing loop downward with the groove on the bottom of the water
chamber, as shown in the figure.
Groove of The
Sealing Loop
Groove on The Bottom
of The Water Chamber
Sealing Loop
The Bottom of The
Water Chamber
Fig. 4-12
WARNING!
• Please be sure to install the sealing loop in accordance with the above method. If the sealing
loop is installed backward, after the chamber is filled with water, the reversal will cause water
leakage.
To Next Page
Loading...
General